Here’s the FlowPaw Rev0 with four Claws fitted!
In this case a buzzer, a LED display, a capacitive touch sensor and an infrared proximity sensor.
The board spec was:
- USB 2 HID interface
- 4 Mikro Bus Claws
- 4 x Coloured LED’s
- 4 x Push Buttons
- 8 x RC Servo outs (with external power option)
- 16 Digital Ins
- 16 Digital Out
- 4 x 12 Bit Analogue Ins
- Reset Button
- Powerful ARM Cortex 4 Microprocessor
The design was worked out with MikroElektonika and within a matter of weeks the first prototype boards were on our desk!