DSP Robotics Support

Hi FS Users,

i was a long time not present here...

So just to place a request here is a little Embarrassing; as a technician i know how to build this with real parts or in a cad simulation, but in FS i'm overwhelmed how to emulate the OPTO-Compressor behaviour.

And on top: i would like to use it in my newest project(s) (with credits - of course)!

Thanks in advance!
Walter

G'day Walter,
While you were away there was a mass 'Exodus' of FS users who have migrated to 309 Discord forum.
I suggest you try the 309 Discord forum, you'll might get a reply over there, as this forum, unfortunately
has become a graveyard...snails move faster than these forum pages.
Anyway, good to here from you, hope you are well