Page 2 of 2
Re: display error
Posted: Sat Jul 05, 2014 9:04 pm
by tester
That's why it's spooky.
On all my machines (XP) it causes FS crash.
Re: display error
Posted: Sun Jul 06, 2014 6:32 am
by billv
Tested on XP (desktop and laptop).. no crash from a double-click start.
Re: display error
Posted: Sun Jul 06, 2014 9:01 am
by tester
...and funny thing is - if I reedit/reset (somehow) input values going from gui - it will probably start work fine.
Re: display error
Posted: Sun Jul 06, 2014 12:05 pm
by trogluddite
No problems here on either of my XP machines.
Re: display error
Posted: Sun Jul 06, 2014 12:15 pm
by tester
Well - something must causing this here, because this happens on separate and different computers, with similar but not the same software/system configuration. But since these issues are not permanent (can be fixed by messing with data flow within the schematic), it's not a great problem. It's just worth to be aware of it for now.
Re: display error
Posted: Fri Jul 11, 2014 10:48 pm
by tester
Note from devs. This and similar on-start crash issues are fixed for the next release.